REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL ENGINE REAR OIL SEAL


    1. A00OLEQE02

      Apply MP grease to the lip of a new oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A00OILJE01

      Using SST, hold the crankshaft.

      SST
      09330-00021
      09213-58014   ( 91551-80840 )
    2. A00OJ8VE01

      Install the front spacer, drive plate and rear spacer onto the crankshaft.

    3. A00OKOTE03

      Clean the bolts and bolt holes.

    4. Apply adhesive to 2 or 3 threads at the end of the 8 bolts.

      Text in Illustration
      *1 Adhesive
      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    5. A00OIVR

      Install the front spacer, drive plate and rear spacer with the 8 bolts. Uniformly tighten the 8 bolts.

      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY


    1. Install the automatic transaxle assembly Click here.

  4. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE


    1. Install the engine assembly with transaxle Click here.