REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL ENGINE REAR OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

    2. A00DTP6E04

      Using SST and a hammer, tap in the oil seal until its surface is flush with the oil seal retainer edge.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Keep the lip free from foreign matter.

      • Do not tap on the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. Clean the 8 bolts and 8 bolt holes.

    2. A00OIMRE04

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
    3. A00ON8J

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A00OJVSE03
      Text in Illustration
      *1 Drive Plate
      *2 Transaxle Side
      *3 Rear Drive Plate Spacer

      Install the drive plate and rear drive plate spacer onto the crankshaft.

    5. A00ON8VE09

      Apply a few drops of adhesive to 2 or 3 threads of the tip of each mounting bolt.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A00OKN4E03

      Using several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY


    1. Install the automatic transaxle Click here.