ECM INSTALLATION


  1. INSTALL ECM


    1. A00DRXH

      Install the No. 1 ECM bracket and No. 2 ECM bracket to the ECM with the 4 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }
    2. A00DU5R

      Install the ECM with the 2 bolts.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

    3. Connect the 2 ECM connectors.


      1. A00DTQV

        Connect the 2 ECM connectors and lower the 2 levers.

        Note


        • When connecting the connectors, make sure that dirt, water or other foreign matter does not get caught between the connectors and other parts.

        • Make sure that the 2 levers are securely lowered.

    4. A00DS11

      Connect the wire harness clamp.

  2. CONNECT NO. 2 AIR CLEANER INLET


    1. A00DRVI

      Connect the No. 2 air cleaner inlet to the vehicle body with the bolt.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

  3. INSTALL NO. 1 AIR CLEANER INLET


    1. A00DUX8

      Attach the 2 claws to install the No. 1 air cleaner inlet.

    2. Install the clip.

  4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY


    1. A00DQ1D

      Install the air cleaner case with the 3 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Attach the wire harness clamp to the air cleaner case.

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A005W5Q

      Connect the air cleaner cap with the band.

    2. Connect the ventilation hose.

    3. A005U5E

      Connect the 2 clamps.

    4. A005UEV

      Attach the wire harness to the 2 clamps.

    5. Connect the mass air flow meter connector.

  6. INSTALL NO. 2 CYLINDER HEAD COVER


    1. A005VFG

      Attach the 4 clips to install the cover.

      Note


      • Be sure to attach the clips securely.

      • Do not apply excessive force or hit the cover to attach the clips. This may cause the cover to break.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL RADIATOR SUPPORT OPENING COVER


    1. A00DRS1

      Install the radiator support opening cover with the 8 clips.

  9. INSTALL ENGINE ROOM SIDE COVER


    1. A00DRIG

      Install the engine room side cover with the clip.

  10. RESET MEMORY


    1. When replacing the ECM, perform the Reset Memory procedure (A/T initialization) Click here.