ECM REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A005RE1

      Remove the clip and engine room side cover.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A005SU5

      Remove the 8 clips and radiator support opening cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A005VFG

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A005UEV

      Disconnect the mass air flow meter connector.

    2. Detach the wire harness from the 2 clamps.

    3. A005U5E

      Disconnect the 2 clamps.

    4. A005W5Q

      Disconnect the ventilation hose.

    5. Loosen the band and remove the air cleaner cap.

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A00DQ1D

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  7. REMOVE NO. 1 AIR CLEANER INLET


    1. A00DUX8

      Remove the clip.

    2. Detach the 2 claws and remove the No. 1 air cleaner inlet.

  8. DISCONNECT NO. 2 AIR CLEANER INLET


    1. A00DRVI

      Remove the bolt and disconnect the No. 2 air cleaner inlet from the vehicle body.

  9. REMOVE ECM


    1. A00DS11

      Disconnect the wire harness clamp.

    2. Disconnect the 2 ECM connectors.


      1. A00DSLO

        Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    3. A00DU5R

      Remove the 2 bolts and ECM.

    4. A00DRXH

      Remove the 4 screws, No. 1 ECM bracket and No. 2 ECM bracket.