ПЕРВИЧНЫЙ ВАЛ УСТАНОВКА


  1. INSTALL INPUT SHAFT FRONT BEARING

    A01J7ACE01

    1. Using SST and a press, press in a new front bearing to the input shaft.

      SST
      09950-60010   ( 09951-00570 )
      09950-70010   ( 09951-07100 )

      Note

      Set the snap ring groove of the input shaft front bearing to the front side.

  2. INSTALL FRONT BEARING SHAFT SNAP RING


    1. Select a snap ring that makes the clearance between the input shaft and front bearing within the specification.

      Standard clearance
      0.10 mm (0.0039 in.) or less
      Standard snap ring thickness
      Mark Thickness
      A 2.10 to 2.15 mm (0.0827 to 0.0846 in.)
      B 2.15 to 2.20 mm (0.0846 to 0.0866 in.)
      C 2.20 to 2.25 mm (0.0866 to 0.0886 in.)
      D 2.25 to 2.30 mm (0.0886 to 0.0906 in.)
      E 2.30 to 2.35 mm (0.0906 to 0.0925 in.)
      F 2.35 to 2.40 mm (0.0925 to 0.0945 in.)
      G 2.40 to 2.45 mm (0.0945 to 0.0965 in.)
    2. A01J4ALE02

      Using a snap ring expander, install the snap ring.

  3. INSTALL INPUT SHAFT BEARING


    1. A01J5AVE02

      Apply gear oil to the input shaft bearing, and install it to the input shaft.

  4. INSTALL NO. 2 SYNCHRONIZER RING


    1. A01J341E02

      Apply gear oil to the No. 2 synchronizer ring, and install it to the input shaft.