КОРПУС КЛАПАНОВ В СБОРЕ УСТАНОВКА


  1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

    A01J427E01

    1. Insert the pin of the lever into the hole of the manual valve.

    2. Install 3 new drum seal gaskets onto the transmission case.

    3. A01J64ME02

      Install the 19 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      Bolt length
      36 mm (1.42 in.) for bolt A
      25 mm (0.98 in.) for bolt B

  2. CONNECT TRANSMISSION WIRE

    A01J331E03

    1. Connect the 7 connectors to the solenoid valves.

    2. Install the clamp with the 2 bolts.

      Torque:
      10 N*m  { 100 kgf*cm, 7 in.*lbf, for bolt A }
      11 N*m  { 110 kgf*cm, 8 ft.*lbf, for bolt B }

      Tech Tips

      Each bolt length is indicated below.

      Bolt length
      36 mm (1.42 in.) for bolt A
      12 mm (0.47 in.) for bolt B

    3. Connect the ATF temperature sensor.

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01J5WWE01

    1. Install a new O-ring and the oil strainer with the 4 bolts.

      Torque:
      10 N*m  { 100 kgf*cm, 7 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01J7BGE01

    Tech Tips

    Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


    1. Install a new gasket and the oil pan with the 20 bolts.

      Torque:
      4.4 N*m  { 45 kgf*cm, 39 in.*lbf }

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  6. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  7. ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid Click here.

  8. INSPECT AUTOMATIC TRANSMISSION FLUID


    1. Inspect the automatic transmission fluid Click here.