ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ УСТАНОВКА


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tech Tips

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.


    1. Install the park/neutral position switch to the manual valve shaft.

    2. A01J3IKE01

      Temporarily install the bolt.

    3. Install a new lock washer and the nut.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
    4. A01J3SBE01

      Push the control shaft rearward as much as possible.

    5. Return the control shaft lever 2 notches to the N position.

    6. A01J3DQE07

      Align the neutral basic line with the switch groove, and tighten the bolt.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

    7. Using a screwdriver, bend the tabs of the lock washer.

  2. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  4. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

  5. ADJUST SHIFT LEVER POSITION

    A01J4K8E01

    1. Remove the nut and disconnect the control cable.

    2. Remove the clip and disconnect the control cable from the control cable bracket.

    3. A01J3SBE01

      Push the control shaft rearward as much as possible.

    4. Return the control shaft lever 2 notches to the N position.

    5. While holding the control shaft lever slightly toward the R position side, tighten the nut.

      Torque:
      15.6 N*m  { 159 kgf*cm, 12 ft.*lbf }

  6. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

    2. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves rearward after shifting to R.

      If the results are not as specified, inspect the park/neutral position switch and check the shift lever.

  7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Apply the parking brake and turn the ignition switch ON.

    2. Depress the brake pedal and check that the engine starts when the shift lever is on N or P, but does not start in other positions.

    3. Check that the back-up light illuminates and the reverse warning buzzer sounds when the shift lever is on R, but do not function in other positions.