ЖГУТ ЭЛЕКТРОПРОВОДКИ ТРАНСМИССИИ СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 205 kgf*cm, 15 ft.*lbf }

  3. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

    A01J3NQ

    1. Remove the oil dipstick.

    2. Remove the 2 bolts and oil filler tube.

    3. Remove the O-ring from the oil filler tube.

  4. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01J4I7E03

    1. Remove the 19 bolts.

    2. A01J4OKE04

      Insert an oil pan seal cutter between the transmission case and oil pan. Cut through the seal and remove the oil pan.

      Note


      • Be careful not to damage the oil pan flange.

      • Some fluid will remain in the oil pan. Carefully remove the oil pan.

    3. A01J63YE01

      Examine the particles in the oil pan.


      1. Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to determine the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

    A01J7GRE02

    1. Remove the 4 bolts and oil strainer.

      Note

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the 3 gaskets from the oil strainer.

  6. REMOVE TRANSMISSION WIRE

    A01J3JG

    1. Disconnect the 4 connectors from the 4 shift solenoid valves.

    2. A01J62DE01

      Remove the bolt and stopper plate from the case.

    3. Pull out the transmission wire from the transmission case.

    4. Remove the O-ring from the transmission wire.