ДЕМПФЕР ПУЛЬСАЦИЙ ДАВЛЕНИЯ В ТОПЛИВНОЙ СИСТЕМЕ СНЯТИЕ


  1. DISCHARGE FUEL SYSTEM PRESSURE

    CAUTION:


    • Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.

    • Even after discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce the risk of fuel spray on yourself or in the engine compartment.


    1. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    2. A01J63PE01

      Disconnect the fuel pump connector.

    3. Connect the cable to the negative (-) battery terminal.

    4. Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.

      Tech Tips

      DTC P0171/25 (system too lean) may be set.

    5. Crank the engine again, and check that the engine does not start.

    6. Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.

    7. Connect the fuel pump connector.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  3. REMOVE V-BANK COVER


    1. Remove the 2 nuts and cover.

  4. DISCONNECT NO. 2 VENTILATION HOSE

    A01J3PAE01

  5. REMOVE AIR CLEANER ASSEMBLY


    1. A01J6D5

      Disconnect the vacuum hose.

    2. Disconnect the MAF meter connector.

    3. Remove the 2 wire harness clamps.

    4. A01J4E3

      Loosen the 2 hose clamps.

    5. Remove the 2 bolts and air cleaner.

  6. REMOVE INTAKE AIR SURGE TANK


    1. A01J63DE01

      Disconnect the No. 5 water by-pass hose.

    2. A01J7LHE01

      Disconnect the No. 4 water by-pass hose.

    3. A01J52XE01

      Disconnect the purge line hose.

    4. A01J5ZIE01

      Disconnect the No. 1 ventilation hose.

    5. A01J78AE01

      Disconnect the purge VSV connector.

    6. Disconnect the VSV (for ACIS) connector.

    7. Disconnect the throttle position sensor and control motor connector.

    8. Remove the 3 wire harness clamps and hose clamp.

    9. A01J3J7E01

      Remove the 3 upper bolts, which are used to secure the 2 surge tank stays and throttle body bracket.

    10. A01J7FME01

      Using an 8 mm hexagon wrench, remove the 4 bolts.

    11. Remove the 2 nuts, intake air surge tank and gasket.

  7. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

    A01J3TZE02

    1. Remove the clip.

    2. Pull out the fuel pressure pulsation damper from the fuel delivery pipe.