ДАТЧИК ТЕМПЕРАТУРЫ ОХЛАЖДАЮЩЕЙ ЖИДКОСТИ СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE V-BANK COVER


    1. A01J56U

      Remove the 2 nuts and V-bank cover.

  3. DISCONNECT NO. 2 VENTILATION HOSE

    A01J3PA

  4. REMOVE AIR CLEANER ASSEMBLY


    1. A01J6D5

      Disconnect the vacuum hose.

    2. Disconnect the MAF meter connector.

    3. Remove the 2 wire harness clamps.

    4. A01J4E3

      Loosen the 2 hose clamps.

    5. Remove the 2 bolts and air cleaner.

  5. REMOVE THROTTLE BODY


    1. A01J7IS

      Disconnect the throttle position sensor and control motor connector.

    2. Remove the 4 bolts and throttle body.

    3. Remove the gasket from the intake air surge tank.

  6. REMOVE INTAKE AIR SURGE TANK


    1. A01J63DE01

      Disconnect the No. 5 water by-pass hose.

    2. A01J7LHE01

      Disconnect the No. 4 water by-pass hose.

    3. A01J52XE01

      Disconnect the purge line hose.

    4. A01J5ZIE01

      Disconnect the No. 1 ventilation hose.

    5. A01J78AE01

      Disconnect the purge VSV connector.

    6. Disconnect the VSV (for ACIS) connector.

    7. Disconnect the throttle position sensor and control motor connector.

    8. Remove the 3 wire harness clamps and hose clamp.

    9. A01J3J7E01

      Remove the 3 upper bolts, which are used to secure the 2 surge tank stays and throttle body bracket.

    10. A01J7FME01

      Using an 8 mm hexagon wrench, remove the 4 bolts.

    11. Remove the 2 nuts, intake air surge tank and gasket.

  7. REMOVE INTAKE MANIFOLD


    1. A01J6ISE01

      Disconnect the 6 fuel injector connectors.

    2. Remove the 10 bolts, intake manifold and 2 gaskets.

  8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

    A01J3JY

    1. Disconnect the sensor connector.

    2. Remove the sensor.

    3. Remove the gasket from the sensor.