ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A01J3WHE01

      Apply a light coat of engine oil to the O-ring of the sensor.

    2. Install the sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    3. Connect the sensor connector.

  2. INSTALL COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)


    1. A01J6LEE01

      Temporarily install the compressor with the bolt labeled A.

    2. Install the compressor completely by tightening the 4 bolts in the order shown in the illustration.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      In order to prevent misalignment, which causes belt rattle, tightening of the bolts must be performed in the order shown.

    3. Connect the compressor connector.

    4. A01J5Y5

      Connect the suction hose with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  3. INSTALL GENERATOR ASSEMBLY (w/ Air Conditioning System)

    A01J5AE

    1. Install the generator and adjusting bar with the 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

    2. Install the generator wire with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Install the terminal cap.

    4. Connect the generator connector.

  4. INSTALL IDLER PULLEY (w/o Air Conditioning System)


    1. A01J4ZE

      Install the idler pulley with the 3 bolts.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

  5. INSTALL DRIVE BELT


    1. A01J3ZEE02

      Временно установите натяжитель поликлинового ремня и закрепите его 5 болтами.

    2. Установите натяжитель поликлинового ремня и закрепите его болтом 1, а затем болтом 2.

      Torque:
      36 Н*м  { 367 кгс*см, 27 фунт-сила-футов }

    3. Затяните остальные болты.

      Torque:
      36 Н*м  { 367 кгс*см, 27 фунт-сила-футов }

      Tech Tips

      Ниже указана длина каждого болта.

      A = 70 мм (2,76 дюйма)

      B = 33 мм (1,30 дюйма)

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  7. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.