REAR SPOILER REMOVAL


  1. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A0043TV

      Using a moulding remover, disengage the 4 clips and 4 claws, and remove the upper back door trim panel assembly.

  2. REMOVE BACK DOOR SIDE GARNISH RH


    1. A0043NX

      Disengage the 3 clips and 2 claws, and remove the back door side garnish RH.

  3. REMOVE BACK DOOR SIDE GARNISH LH


    1. A0043SN

      Disengage the 3 clips and 2 claws, and remove the back door side garnish LH.

  4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    1. A0040AI

      Using a moulding remover, disengage the clip and claw.

    2. A00409C

      Using a moulding remover, disengage the clip and claw.

    3. A0040K2E01

      Disengage the 3 clips in the order shown in the illustration.

    4. A0043OY

      Disengage the 2 clips by pulling the back door trim board assembly in the direction indicated by the arrows in the illustration.

    5. A0043CXE01
      Text in Illustration
      *1 Back Door Trim Board Assembly
      *2 Back Door Panel
      *a The portion that may be damaged due to interference

      Remove the back door trim board assembly by pulling it in the direction indicated by the arrow in the illustration to disengage the 4 clips.

      Note

      Make sure to pull the back door trim board assembly in the direction indicated by the arrow in the illustration. If the back door trim board assembly is removed from the lower part, the door pull handle mounting area may interfere with the back door panel, resulting in damage to the back door trim board assembly.

  5. REMOVE BACK DOOR TRIM BOARD


    1. A0042Y4

      Disengage the 5 clips and 2 guides, and remove the back door trim board.

  6. REMOVE REAR SPOILER ASSEMBLY


    1. A00404P

      Disconnect the connector.

    2. Remove the 5 nuts.

    3. A0041EV

      Disengage the 2 clips to remove the rear spoiler assembly.

  7. REMOVE CENTER STOP LIGHT SET


    1. A0042KEE01
      Text in Illustration
      *1 Wire

      Secure a wire around the center stop light set wire harness as shown in the illustration.

      Note

      Use a wire long enough so that the center stop light set wire harness can be passed through the rear spoiler assembly during installation.

    2. Remove the 2 screws.

    3. A0040Y7E01
      Text in Illustration
      *1 Wire Harness
      *2 Gasket
      *3 Wire
      *4 Protective Tape
      *5 Cloth

      Place a cloth on the rear spoiler assembly as shown in the illustration.

    4. Using a clip remover wrapped with protective tape, widen the space inside the rear spoiler assembly, and pull the center stop light set wire harness to remove it as shown in the illustration.

      Note


      • Do not apply excess force to the rear spoiler assembly or it may be damaged.

      • Do not damage the gasket of the rear spoiler assembly.

      • Do not apply excess force when pulling the wire harness or it may break.

    5. Remove the wire from the old center stop light set wire harness.

  8. REMOVE REAR SIDE SPOILER LH


    1. A0040GF

      Remove the screw.

    2. Disengage the guide and remove the rear side spoiler LH.

  9. REMOVE REAR SIDE SPOILER RH

    Tech Tips

    Use the same procedure for the RH side and LH side.