TURN SIGNAL FLASHER ASSEMBLY INSPECTION


  1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    1. A0041OFE67
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Turn Signal Flasher Assembly)

      Disconnect the L46 turn signal flasher assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L46-1 (IG) - Body ground Power switch off Below 1 V
      Power switch on (IG) 11 to 14 V
      L46-4 (B) - Body ground Always 11 to 14 V

      If the result is not as specified, repair or replace the wire harness or connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L46-5 (EL) - Body ground Turn signal switch in neutral position 10 kΩ or higher
      Turn signal switch in left turn position Below 1 Ω
      L46-6 (ER) - Body ground Turn signal switch in neutral position 10 kΩ or higher
      Turn signal switch in right turn position Below 1 Ω
      L46-7 (E) - Body ground Always Below 1 Ω
      L46-8 (HAZ) - Body ground Hazard warning switch off 10 kΩ or higher
      Hazard warning switch on Below 1 Ω

      If the result is not as specified, repair or replace the wire harness or connector.

    4. A0042NCE23
      Text in Illustration
      *a

      Component with harness connected

      (Turn Signal Flasher Assembly)

      Reconnect the L46 turn signal flasher assembly connector.

    5. Measure the voltage according to the valve(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L46-2 (LR) - Body ground Hazard warning switch off Below 1 V
      Hazard warning switch on 11 to 14 V (60 to 120 times per minute)
      Turn signal switch off Below 1 V
      Power switch on (IG) and turn signal switch in RH position 11 to 14 V (60 to 120 times per minute)
      L46-3 (LL) - Body ground Hazard warning switch off Below 1 V
      Hazard warning switch on 11 to 14 V (60 to 120 times per minute)
      Turn signal switch off Below 1 V
      Power switch on (IG) and turn signal switch in LH position 11 to 14 V (60 to 120 times per minute)

      If the result is not as specified, the turn signal flasher assembly may have a malfunction.