HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL


  1. REMOVE FRONT WHEEL LH (for LHD)

  2. REMOVE FRONT WHEEL RH (for RHD)

  3. REMOVE FRONT FENDER LINER LH (for LHD)

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  4. REMOVE FRONT FENDER LINER RH (for RHD)


    1. A0044AQE01

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    2. A0043PN

      Remove the 10 clips and 4 screws.

    3. Using a clip remover, remove the grommet and front fender liner RH.

      Tech Tips

      The grommet needs to be replaced with new one because it will break when it is removed.

  5. REMOVE FRONT DOOR SCUFF PLATE


    1. A0042VN

      Disengage the 10 claws and remove the front door scuff plate LH.

  6. REMOVE COWL SIDE TRIM BOARD


    1. A0042AR

      Remove the clip.

    2. Disengage the 2 clips and remove the cowl side trim board LH.

  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY


    1. A0041MT

      Remove the screw <C>.

    2. A00438O

      Disengage the 6 claws and clip as shown in the illustration.

    3. A00436H

      Disengage the claw and 2 guides and disconnect the hood lock control cable.

    4. Disconnect each connector and clamp, and remove the lower instrument panel finish panel assembly.

  8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A0042O0

      Disconnect the hood lock control cable assembly from the hood lock control lever sub-assembly.

  9. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. A00422Z

      Disconnect the hood lock control cable assembly.

    2. Using a screwdriver, disengage each clamp shown in the illustration.

      A0041Q3E01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Grommet
      *3 Hood Cable Grommet - -

      Tech Tips

      Tape the screwdriver tip before use.

    3. Pull the hood lock control cable assembly from the engine compartment and remove it.

  10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. A0044AF

      Disconnect the hood lock control cable assembly.

    2. Using a screwdriver, disengage each clamp shown in the illustration.

      A0043H9E01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Grommet
      *3 Hood Cable Grommet - -

      Tech Tips

      Tape the screwdriver tip before use.

    3. Pull the hood lock control cable assembly from the engine compartment and remove it.