FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION


  1. INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


    1. A0040BUE01
      Text in Illustration
      *1 From Tank
      *2 Fixed Part
      *3 Sensor Part

      Install the front evaporator temperature sensor (No. 1 cooler thermistor) as shown in the illustration.

      Part Length
      A 175 mm 6.89 in.
      B 161.6 mm 6.36 in.
      C 87.9 mm 3.46 in.
      D 50 mm 1.97 in.

      Note


      • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).

      • After inserting the thermistor, do not apply excessive force to the wire.

      • Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    1. A0040HE

      Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces.

      Compressor oil
      ND-OIL 11 or equivalent

    2. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

      Note


      • Keep the O-rings and O-ring fitting surfaces free from dirt or any foreign objects.

      • Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.

    3. A0042BR

      Engage the clamp and install the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor.

      Tech Tips

      Completely cover the tube with the grommet.

    4. A0043VZ

      Engage the 4 claws.

    5. Install the lower heater case with the 4 screws.

    6. A0042IK

      Install the packing.

  3. INSTALL COOLER EXPANSION VALVE


    1. A0040F4

      Using a 4 mm hexagon socket wrench, install the cooler expansion valve with the 2 hexagon bolts.

      Torque:
      3.5 N*m  { 36 kgf*cm, 31 in.*lbf }

  4. INSTALL BLOWER ASSEMBLY

    Click here