SEAT BELT CONTROL ECU INSTALLATION

INSTALL ECU INTEGRATION BOX RH (for LHD)

1. Install the ECU integration box with the bolt and 2 nuts.

   Torque:

   Bolt

   8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   Nut

   5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

2. Engage the 3 clamps to connect the wire harness.

3. Connect each connector.

INSTALL ECU INTEGRATION BOX LH (for RHD)

1. Install the ECU integration box with the bolt and nut.

   Torque:

   Bolt

   8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   Nut

   5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

2. Engage the clamp to connect the wire harness.

3. Connect each connector.

INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

1. 

   Text in Illustration

   *a	Opened Approximately 55°
   *b	Closed

   With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.

   Note

   Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.

2. 

   Text in Illustration

   *1	Glove Compartment Door Stopper Sub-assembly
   *2	Stopper

   Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.

3. Engage the claw and connect the glove compartment door stopper sub-assembly.

INSTALL REAR NO. 3 FLOOR BOARD UPPER PLATE

1. Engage the 2 claws to install the rear No. 3 floor board upper plate.

INSTALL DECK FLOOR BOX RH

1. Engage the claw and 4 guide to install the deck floor box RH.

INSTALL REAR NO. 3 FLOOR BOARD

1. Install the rear No. 3 floor board.