AIRBAG CUT-OFF SWITCH INSTALLATION


  1. INSTALL AIRBAG CUT-OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. Engage the 2 claws to install the airbag cut-off switch cylinder sub-assembly.

  2. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


    1. w/ Airbag Cut Off Switch


      1. Connect the connector.

    2. A00418L

      Engage the guide as shown in the illustration.

    3. A004422

      Engage the guide as shown in the illustration.

    4. A0041N3

      Engage the 4 claws to install the instrument panel finish panel end RH.

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL REAR NO. 3 FLOOR BOARD UPPER PLATE


    1. Engage the 2 claws to install the rear No. 3 floor board upper plate.

  5. INSTALL DECK FLOOR BOX RH


    1. Install the deck floor box RH Click here.

    2. Install the rear No. 2 floor board.

  6. INSTALL REAR NO. 3 FLOOR BOARD


    1. Install the rear No. 3 floor board.

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. INSPECT SRS WARNING LIGHT

    Click here