SEAT BELT CONTROL ECU REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  3. REMOVE DECK FLOOR BOX RH


    1. A00440B

      Disengage the claw and 4 guides and remove the deck floor box RH.

  4. REMOVE REAR NO. 3 FLOOR BOARD UPPER PLATE


    1. A0040W5

      Disengage the 2 claws and remove the rear No. 3 floor board upper plate.

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    1. for LHD:


      1. A004427E01
        Text in Illustration
        *1 Glove Compartment Door Stopper Sub-assembly
        *2 Moulding Remover
        *3 Lower Instrument Panel Sub-assembly
        *4 Glove Compartment Door Assembly
        *5 Stopper

        Disengage the claw and release the glove compartment door stopper sub-assembly.

      2. Insert the moulding remover into the location shown in the illustration.

      3. Move the moulding remover in the direction indicated by the arrow to bend the lower instrument panel sub-assembly and release the stopper (A).

        Tech Tips

        Use the same procedure to release the stopper (B).

    2. for RHD:


      1. A0043ACE01
        Text in Illustration
        *1 Glove Compartment Door Stopper Sub-assembly
        *2 Stopper

        Disengage the claw and release the glove compartment door stopper sub-assembly.

      2. Slightly bend stoppers (A) and (B) in the directions indicated by the arrows in the illustration and pull the glove compartment door assembly until the stoppers are released.

    3. A00430KE01
      Text in Illustration
      *a Close
      *b Open Approximately

      Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.

      Note

      Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.

  7. REMOVE ECU INTEGRATION BOX RH (for LHD)


    1. Disconnect each connector.

    2. A0041AA

      Disengage the clamp and disconnect the wire harness.

    3. Remove the bolt, nut and ECU integration box.

  8. REMOVE ECU INTEGRATION BOX LH (for RHD)


    1. Disconnect each connector.

    2. A0041AA

      Disengage the clamp and disconnect the wire harness.

    3. Remove the bolt, nut and ECU integration box.

  9. REMOVE SEAT BELT CONTROL ECU (for LHD)


    1. A004007

      Disengage the 2 claws and remove the seat belt control ECU.

  10. REMOVE SEAT BELT CONTROL ECU (for RHD)


    1. A0043FW

      Disengage the 2 claws and remove the seat belt control ECU.