CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly with the 5 hooks.

      Note


      • When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

      • Do not twist the curtain shield airbag assembly when installing it.

    4. Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers.


      1. A00434PE04
        Text in Illustration
        *1 Pin
        *2 Clip
        *3 Airbag
        *4 Body
        *5 Spacer

        Install 4 new pins as shown in the illustration.

        Note

        Make sure that the pins of the clips are pushed in firmly.

    5. Install 5 new bolts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
    6. A00432WE01
      Text in Illustration
      *1 Airbag Connector
      *2 Airbag Connector Lock

      Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    7. Push in the lock to install the curtain shield airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here