TRANSMITTER BATTERY REPLACEMENT


  1. REMOVE TRANSMITTER BATTERY

    Note

    Take extra care when handling these precision electronic components.


    1. A00410T

      Push the release hook knob and extract the mechanical key as shown in the illustration.

    2. A0041NME01
      Text in Illustration
      *1 Protective Tape

      Insert a screwdriver into the gap, and turn the screwdriver to detach the transmitter housing cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A0041IWE01
      Text in Illustration
      *1 Protective Tape

      Insert a precision screwdriver into the gap and remove the transmitter battery (lithium battery: CR1632).

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the transmitter battery. The terminals may be damaged.

      • Do not touch the transmitter battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

      • To prevent the transmitter from being damaged, be sure to touch a grounded metal surface with your bare hands to discharge any static electricity before replacing the transmitter battery.

      Tech Tips

      Tape the screwdriver tip before use.

  2. INSTALL TRANSMITTER BATTERY


    1. A0043OC

      Install a new transmitter battery (lithium battery: CR1632) with the positive (+) side facing upward as shown in the illustration.

      Note


      • Be sure that the positive (+) side and the negative (-) side of the transmitter battery are matched correctly.

      • Be careful not to bend the electrodes while installing the transmitter battery.

      • Keep the interior of the transmitter housing case free of dust, water and oil.

      • To prevent the transmitter from being damaged, be sure to touch a grounded metal surface with your bare hands to discharge any static electricity before replacing the transmitter battery.

    2. A004063

      Install the transmitter housing cover by pressing down on it as shown in the illustration.

    3. A0042DQ

      Insert the mechanical key into the transmitter.

    4. Press one of the transmitter switches and check that the LED illuminates.

      OK
      Transmitter LED illuminates when switch is pressed.