POWER MANAGEMENT CONTROL ECU INSTALLATION


  1. INSTALL POWER MANAGEMENT CONTROL ECU (for LHD)


    1. Engage the 2 claws to install the power management control ECU.

  2. INSTALL POWER MANAGEMENT CONTROL ECU (for RHD)


    1. Engage the 2 claws to install the power management control ECU.

  3. INSTALL ECU INTEGRATION BOX (for LHD)


    1. Install the ECU integration box with the bolt and 2 nuts.

      Torque:
      Bolt
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
      Nut
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Engage the 3 clamps to connect the wire harness.

    3. Connect each connector.

  4. INSTALL ECU INTEGRATION BOX (for RHD)


    1. Install the ECU integration box with the bolt and nut.

      Torque:
      Bolt
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
      Nut
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Engage the clamp to connect the wire harness.

    3. Connect each connector.

  5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. A0041APE01
      Text in Illustration
      *a Opened Approximately 55°
      *b Closed

      With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.

      Note

      Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.

    2. A0041BCE01
      Text in Illustration
      *1 Glove Compartment Door Stopper Sub-assembly
      *2 Stopper

      Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.

    3. Engage the claw and connect the glove compartment door stopper sub-assembly.

  6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the guide and 3 claws to install the No. 2 instrument panel under cover sub-assembly.

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL REAR NO. 3 FLOOR BOARD UPPER PLATE


    1. Engage the 2 claws to install the rear No. 3 floor board upper plate.

  9. INSTALL DECK FLOOR BOX RH


    1. Install the deck floor box RH Click here.

    2. Install the rear No. 2 floor board.

  10. INSTALL REAR NO. 3 FLOOR BOARD


    1. Install the rear No. 3 floor board.