DATA LIST
Tech Tips
Using the GTS to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Entire the following menus: Powertrain / Radar Cruise / Data List.
According to the display on the GTS, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Cruise Control Main Switch | Cruise control switch signal / ON or OFF | ON: Cruise control switch (ON-OFF button) pushed OFF: Cruise control switch (ON-OFF button) released |
- |
| RES/ACC Switch | +/RES switch signal / ON or OFF | ON: +/RES switch on OFF: +/RES switch off |
- |
| SET/COAST Switch | -/SET switch signal / ON or OFF | ON: -/SET switch on OFF: -/SET switch off |
- |
| Distance Control Switch | Distance control switch signal / ON or OFF | ON: Distance control switch on OFF: Distance control switch off |
- |
| Snow Switch | SNOW switch signal / ON or OFF | ON: SNOW switch on OFF: SNOW switch off |
Not supported |
| PCS Brake OFF Switch | Pre-crash safety system cancel switch assembly status/ ON or OFF |
ON: Pre-crash safety system cancel switch assembly on OFF: Pre-crash safety system cancel switch assembly off |
- |
| Cruise Control | Cruise control system operation signal / ON or OFF | ON: Cruise control system operating OFF: Cruise control system not operating |
- |
| Constant Speed Mode | Constant speed mode signal / ON or OFF | ON: Dynamic radar cruise control system is in constant speed mode OFF: Dynamic radar cruise control system is in vehicle-to-vehicle distance control mode |
- |
| Cruise Control Mode | Cruise control mode signal / All Spd, Hi Spd or Normal | All Spd: Vehicle-to-vehicle distance control mode (w/ full-speed following function) Hi Spd: Vehicle-to-vehicle distance control mode (w/o full-speed following function) Normal: Constant speed mode |
- |
| CCS Mem Vehicle Spd | Cruise control memorized speed / min.: 0 km/h (0 mph), max.: 320.0 km/h (199 mph) | Memorized speed: Cruise control activated | - |
| Vehicle Distance | Distance to vehicle in front / min.: 0 m (0 ft.), max.: 255 m (836.65 ft.) | Actual distance to vehicle | - |
| Stop Light SW 1 (M CPU) | Stop light switch (Main-CPU) signal / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Stop Light SW 1 (S CPU) | Stop light switch (Sub-CPU) signal / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Stop Light SW 2 (M CPU) | Stop light switch (Main-CPU) signal / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Wiper (Hi) | Windshield wiper switch Hi signal / ON or OFF | ON: Windshield wiper switch Hi position OFF: Windshield wiper switch except Hi position |
- |
| Wiper (Lo) | Windshield wiper switch Lo signal / ON or OFF | ON: Windshield wiper switch Lo position OFF: Windshield wiper switch except Lo position |
- |
| Tail Light | Tail light switch signal / ON or OFF | ON: Tail light switch on OFF: Tail light switch off |
- |
| Vhcl Spd Calc-Whl Spd | Vehicle speed / min.: -327.0 km/h (-203 mph), max.: 327.0 km/h (204 mph) | Actual vehicle speed | - |
| Vhcl Spd-Brake ECU | Vehicle speed / min.: -327.0 km/h (-203 mph), max.: 327.0 km/h (204 mph) | Actual vehicle speed | - |
| Invalid Whl Spd Sens Num | Invalid wheel speed sensor / min.: 0, max.: 255 | Actual invalid wheel speed sensor | - |
| Rear Whl Spd LH Sensor | Rear speed sensor LH signal / Normal or Abnoml | Normal: Rear speed sensor LH is normal Abnoml: Rear speed sensor LH is abnormal |
- |
| Rear Whl Spd RH Sensor | Rear speed sensor RH signal / Normal or Abnoml | Normal: Rear speed sensor RH is normal Abnoml: Rear speed sensor RH is abnormal |
- |
| Front Whl Spd LH Sensor | Front speed sensor LH signal / Normal or Abnoml | Normal: Front speed sensor LH is normal Abnoml: Front speed sensor LH is abnormal |
- |
| Front Whl Spd RH Sensor | Front speed sensor RH signal / Normal or Abnoml | Normal: Front speed sensor RH is normal Abnoml: Front speed sensor RH is abnormal |
- |
| Vehicle Acceleration | Vehicle acceleration / min.: -5.00 m/s2, max.: 5.00 m/s2 | Actual vehicle acceleration | - |
| Whl Spd/Deceleration Sen | Wheel speed sensor/Deceleration sensor signal / Avail or Not Avl | Avail: Wheel speed sensor/Deceleration sensor available Not Avail: Wheel speed sensor/Deceleration sensor not available |
- |
| Closed Throttle Position | Accelerator pedal idle position signal / ON or OFF | ON: Accelerator pedal released OFF: Accelerator pedal depressed |
- |
| Yaw Rate Sensor | Yaw rate value / min.: -100.00 deg/s, max.: 100.00 deg/s | Actual yaw rate value | - |
| Deceleration Sensor 1 | Deceleration value / min.: -14.70 m/s2, max.: 14.70 m/s2 | Actual deceleration value | - |
| Deceleration Sensor 2 | Deceleration value / min.: -14.70 m/s2, max.: 14.70 m/s2 | Actual deceleration value | - |
| Tar Accel for ACC | Target vehicle acceleration for vehicle-to-vehicle distance control mode / min.: -5.10 m/s2, max.: 5.08 m/s2 | Actual target vehicle acceleration | - |
| Tar Accel for CCS | Target vehicle acceleration for constant speed mode / min.: -5.10 m/s2, max.: 5.08 m/s2 | Actual target vehicle acceleration | - |
| Request Driving Force | Cruise control system request drive force / min.: -65536 N, max.: 65534 N | Actual request drive force | - |
| ECM/PCM Command | Origin of the drive force request / Pedal, None or DS | Pedal: Accelerator pedal depressed None: drive force not requested DS: Radar cruise control system operating |
- |
| Max Val of Available DF | Maximum value of available drive force / min.: -65536 N, max.: 65534 N | Actual available drive force maximum value | - |
| Min Val of Available DF | Minimum value of available drive force / min.: -65536 N, max.: 65534 N | Actual available drive force minimum value | - |
| Forward Vhcl Relative Spd | Vehicle ahead relative speed / min.: -128 m/s, max.: 127 m/s | Actual vehicle ahead relative speed | - |
| Vehicle Approach Warning | Forward vehicle approach warning signal / ON or OFF | ON: Forward vehicle approaching OFF: Forward vehicle not approaching |
- |
| Vhcl Stability Ctrl Buzz | Skid control buzzer operation signal / ON or OFF | ON: Skid control buzzer operating OFF: Skid control buzzer not operating |
- |
| Brk Rqst to Elec Ctrl Brk | Braking request to brake control / NotCtrl, None, Exist, None , Exist or Disable | Driving support ECU control demand | - |
| Brk Rqst to Shift Down | Braking request to hybrid control / NotCtrl, None, Exist, None , Exist or Disable | Exist: Braking control request None: Braking control not request |
- |
| Operator Override | Operator override / NotCtrl, Able, Unable or Disable | Able: Able to operate the override Unable: Unable to operate the override |
- |
| Forward Vehicle Detect | Vehicle ahead detection signal / Detect or No Dtct | Detect: Vehicle ahead detected No Dtct: Vehicle ahead not detected |
- |
| CCS Main SW-Ready | Dynamic radar cruise control system standby condition / ON or OFF | ON: Dynamic radar cruise control system standby OFF: Dynamic radar cruise control system not standby |
- |
| CCS System Check | Radar cruise control system warning indication / ON or OFF | ON: Radar cruise control system warning indication (Malfunction detected) OFF: Radar cruise control system warning indication (Malfunction not detected) |
- |
| FRS-Dirt | History of dirt detected on millimeter wave radar sensor / ON or OFF | ON: History of dirt detected on millimeter wave radar sensor OFF: No history of dirt detected on millimeter wave radar sensor |
- |
| Bad Wthr Hist(F Radar Sen) | History of millimeter wave radar sensor detecting bad weather / ON or OFF | ON: History of millimeter wave radar sensor detecting bad weather OFF: No history of millimeter wave radar sensor detecting bad weather |
- |
| Frnt Radar Sens Temp Hi | Millimeter wave radar sensor high temperature abnormality / ON or OFF | ON: Millimeter wave radar sensor abnormal OFF: Millimeter wave radar sensor normal |
- |
| CCS Cancel by Low Spd | Dynamic radar cruise control system (constant speed mode) low speed cancel signal / ON or OFF | ON: Low speed cancel signal ON OFF: Low speed cancel signal OFF |
- |
| Cancl CCS by Com Delay | Dynamic radar cruise control system (constant speed mode) cancel signal / ON or OFF | ON: Cancel signal ON OFF: Cancel signal OFF |
- |
| Cancl CCS by RAM Malfnc | Dynamic radar cruise control system (constant speed mode) cancel signal / ON or OFF | ON: Cancel signal ON OFF: Cancel signal OFF |
- |
| A-CCS Cancl-Radar/Wip | Dynamic radar cruise control system (vehicle-to vehicle distance control mode) cancel signal / ON or OFF | ON: Cancel signal ON OFF: Cancel signal OFF |
- |
| Country# (F Radar Sens) | Millimeter wave radar sensor country signal / JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC, NOFIX | Actual country code | - |
| Steering Angle | Steering angle / min.: -3072.0 deg, max.: 3070.5 deg | Actual steering angle | - |
| Zero Point Angle Sens | Zero point steering angle sensor / min.: -3072.0 deg, max.: 3070.5 deg | Actual zero point steering angle | - |
| Radar | Millimeter wave radar sensor operation signal / Emission or Stop | Emission: Millimeter wave radar sensor signal sent Stop: Millimeter wave radar sensor signal stopped |
- |
| # Codes | Number of present trouble codes / min.: 0, max.: 255 | Number of DTCs will be displayed | - |
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Tests.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
For Cruise Control Indicator Light (Combination Meter Sub-assembly):
Enter the following menus: Body Electrical / Combination Meter / Active Test.
For Skid Control Buzzer (ABS/VSC/TRC):
Enter the following menus: Chassis / ABS/VSC/ TRC / Active Test.
Perform Active Test according to the display on the tester.
Tech Tips
The power switch must be turned on (IG) to proceed with the Active Test using the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator light (Constant speed control mode) |
Cruise control indicator light (Constant speed control mode) ON / OFF | - |
| Indicat. Radar Cruise | Cruise control indicator light (Vehicle-to-vehicle distance control mode) |
Cruise control indicator light (Vehicle-to-vehicle distance control mode) ON / OFF | - |
| Indicat. SET | Cruise control SET indicator light | Cruise control SET indicator light ON / OFF | - |
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| DSS Signal Buzzer | Skid control buzzer | Buzzer OFF or ON | Buzzer can be heard |