EGR VALVE ON-VEHICLE INSPECTION


  1. PERFORM ACTIVE TEST USING GTS (CONTROL THE EGR STEP POSITION)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Put the engine in inspection mode (maintenance mode) Click here.

    5. Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher.

      Tech Tips

      The A/C switch and all accessory switches should be off.

    6. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the EGR Step Position / Data List / All Data / Throttle Idle Position and MAP.

    7. Confirm that the Throttle Idle Position is ON and check the MAP value in the Data List while performing the Active Test.

      Note


      • Do not leave the EGR valve open for 10 seconds or more during the Active Test.

      • Be sure to return the EGR valve to step 0 when the Active Test is completed.

      • Do not open the EGR valve 30 steps or more during the Active Test.

      OK
      MAP change in response to EGR step position when Throttle Idle Position is ON in Data List.
      Standard
      - EGR Step Position (Active Test)
      0 Steps 0 to 30 Steps

      MAP

      (Data List)

      		 (EGR valve is fully closed) MAP value is at least +10 kPa (75 mmHg) higher than when EGR valve is fully closed

      Tech Tips


      • While performing the Active Test, if the increase in the value of MAP is small, the EGR valve assembly may be a malfunctioning.

      • Even if the EGR valve assembly is malfunctioning, rough idling or an increase in the value of MAP may occur while performing the Active Test. However, the amount that the value of MAP increases will be smaller than normal.