PLUG-IN CHARGE CONTROL SYSTEM, Diagnostic DTC:P2511-441

DTC Code DTC Name
P2511-441 Reset Detected

DESCRIPTION

The plugin charge control ECU assembly detects a reset signal while the vehicle is being plug-in charged or driven.

DTC No. INF Code DTC Detection Condition Trouble Area
P2511 441 Reset signal from the WDC monitoring system or the power source IC system, which are built into the plugin charge control ECU assembly, is detected while the vehicle is being plug-in charged or being driven.
  • ECU power source circuit

  • Plugin charge control ECU assembly

WIRING DIAGRAM

Refer to the wiring diagram for ECU power source circuit Click here.

INSPECTION PROCEDURE

Tech Tips

After the repair, turn the power switch on (READY) and wait for 10 seconds or more, or perform plug-in charging for 1 minute or more and disconnect the electric vehicle charger cable assembly. And then turn the power switch on (READY) and wait for 10 seconds or more to check that no DTCs are output.

PROCEDURE


  1. CHECK DTC OUTPUT (PLUG-IN CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.

    4. Check if DTCs are output.

      Result
      Result Proceed to
      P2511-441 only is output. A
      DTCs other than P2511-441 is output. B
    5. Turn the power switch off.


    B
    A
  2. CHECK AUXILIARY BATTERY TERMINAL (CONTACT PROBLEM)


    1. Check the connection of the auxiliary battery terminal.

      OK
      The terminal is connected securely and there is no contact problem.

    NG
    OK
  3. CHECK FOR ECU POWER SOURCE CIRCUIT

    Click here


    NG
    OK
  4. CHECK FOR INTERMITTENT PROBLEMS


    1. Check for intermittent problems Click here.

      Result
      Result Proceed to
      Problem symptom does not recur. A
      Problem symptom recurs. B

    B
    A