HEATED OXYGEN SENSOR INSTALLATION


  1. INSTALL HEATED OXYGEN SENSOR


    1. A0040YCE01
      Text in Illustration
      *1

      Fulcrum Length

      300 mm
      *2

      Fulcrum Length

      30 mm

      Using SST, install the heated oxygen sensor onto the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note


      • This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST with a length of 30 mm (1.18 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

    2. A00445Q

      Connect the wire harness to install the wire harness clamp bracket.

    3. A0043MF

      Install the wire harness clamp bracket with the bolt.

      Torque:
      12 N*m  { 127 kgf*cm, 9 ft.*lbf }

    4. Install the wire harness bracket.

    5. Connect the heated oxygen sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

  3. INSTALL NO. 3 ENGINE UNDER COVER


    1. A00439W

      Install the No. 3 engine under cover with the 4 clips.