AIR FUEL RATIO SENSOR REMOVAL


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for LHD)


    1. A00436K

      Remove the 3 bolts and cowl body mounting reinforcement LH.

  3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    1. A0040EX

      Disengage the clamp and separate the wire harness.

    2. A0041QO

      Disengage the claw and bend the No. 1 heater air duct splash shield seal.

    3. A004113

      Disengage the claw and bend the water guard plate RH.

    4. A0043EB

      Remove the 9 bolts and outer cowl top panel sub-assembly.

  4. REMOVE COWL BODY MOUNTING REINFORCEMENT RH (for RHD)


    1. A0042J0

      Remove the 3 bolts and cowl body mounting reinforcement RH.

  5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    1. A0043SF

      Disengage the clamp and separate the wire harness from the outer cowl top panel sub-assembly.

    2. A00422BE01

      Disengage the clamp*1 and disconnect the connector (w/ Windshield Deicer).

    3. Disengage the clamp*2 and separate the wire harness from the outer cowl top panel sub-assembly.

    4. A0043QY

      Disengage the claw and bend the No. 1 heater air duct splash shield seal.

    5. A0043RA

      Disengage the claw and bend the water guard plate RH.

    6. A0041EP

      Remove the 9 bolts and outer cowl top panel sub-assembly.

  6. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A0042Q6

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

  7. REMOVE AIR FUEL RATIO SENSOR


    1. A004210

      Disconnect the air fuel ratio sensor connector and clamp.

    2. A0042EME01

      Using SST, remove the air fuel ratio sensor.

      SST
      09224-00010