CAMSHAFT POSITION SENSOR REMOVAL

Tech Tips

Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A0042Q6

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

  2. REMOVE NO. 1 CRANK POSITION SENSOR


    1. A00415IE01

      Disconnect the No. 1 crank position sensor connector.

    2. Remove the bolt and No. 1 crank position sensor.