HARD DISK DRIVE REMOVAL


  1. PRECAUTION

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

    • A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the navigation receiver assembly.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  3. REMOVE DECK FLOOR BOX RH


    1. Fold back the rear No. 2 floor board.

    2. Remove the deck floor box RH Click here.

  4. REMOVE REAR NO. 3 FLOOR BOARD UPPER PLATE


    1. A0040W5

      Disengage the 2 claws and remove the rear No. 3 floor board upper plate.

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. A00417SE01
      Text in Illustration
      *a Lift slightly

      Using a moulding remover, slightly lift the panel at the position shown in the illustration.

    2. Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.

    3. Disconnect each connector and remove the integration control and panel assembly.

  7. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A0041IM

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.

    2. A00428K

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Disengage the 14 claws.

      A0042AQ

    2. Disconnect the connector and remove the instrument cluster finish panel garnish.

  9. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. A0040N0

      Disengage the 3 claws.

    2. Disconnect the connector and remove the upper instrument panel finish panel sub-assembly.

  10. REMOVE NAVIGATION RECEIVER WITH BRACKET


    1. A0041W7

      Remove the 4 bolts.

    2. A0042NR

      Disengage the 4 claws and remove the navigation receiver with bracket as shown in the illustration.

    3. Disconnect each connector.

  11. REMOVE NO. 2 RADIO BRACKET


    1. A0040BA

      Remove the 4 screws and No. 2 radio bracket.

  12. REMOVE HARD DISK DRIVE


    1. A00441V

      Remove the 2 screws.

    2. Disengage the 2 guides to remove the cover.

    3. A00400QE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip taped with protective tape, slide the hard disk drive in the direction shown by the arrow in the illustration to remove it.