REAR DOOR SPEAKER REMOVAL


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    1. A00401M

      Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug.

  2. REMOVE DOOR ASSIST GRIP COVER


    1. A003ZX2

      Using a moulding remover, disengage the 6 claws, 2 clips and 3 guides, and remove the door assist grip cover.

  3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A0041MN

      Disengage the 7 claws and 2 guides.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  4. REMOVE REAR DOOR ARMREST COVER


    1. A0041EU

      Remove the rear door armrest cover.

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A0043YGE02
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the rear door panel.

    2. A00429Z

      Remove the 2 screws.

    3. Using a clip remover, disengage the 8 clips.

    4. Pull out the rear door trim board sub-assembly in the direction indicated by the arrow in the illustration.

    5. Raise the rear door trim board sub-assembly and remove the rear door trim board sub-assembly together with the rear door inner glass weatherstrip.

    6. A00437P

      Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

    7. for 8 Speakers:


      1. Disconnect the connector.

  6. REMOVE REAR SPEAKER ASSEMBLY


    1. A0040E8

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads and remove the rear speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

  7. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)


    1. A0040BJ

      Remove the 2 screws and rear No. 2 speaker assembly.