STEERING WHEEL INSTALLATION


  1. INSTALL LOWER STEERING WHEEL BOSS COVER


    1. Engage the 2 pins and 4 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.

  2. INSTALL CRUISE CONTROL SWITCH WIRE

  3. INSTALL CRUISE CONTROL MAIN SWITCH


    1. A0043O5

      Connect the connector.

    2. Install the cruise control main switch with the 2 screws as shown in the illustration.

    3. Engage the clamp.

  4. INSTALL STEERING PAD SWITCH ASSEMBLY


    1. Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.

    2. Install the 2 screws.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

    3. Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.

    4. Install the 2 screws.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  5. INSTALL STEERING SHAKE DAMPER


    1. Install the steering shake damper to the steering wheel assembly with the 2 screws.

      Torque:
      2.4 N*m  { 24 kgf*cm, 21 in.*lbf }

  6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  7. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. A0043LN

      Rotate the spiral cable counterclockwise slowly by hand until it stops.

      Note

      Do not turn the spiral cable using the airbag wire harness.

    4. A0042JHE02
      Text in Illustration
      *a Alignment Mark

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      Note

      Do not turn the spiral cable using the airbag wire harness.

      Tech Tips

      The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

  8. INSTALL STEERING WHEEL ASSEMBLY


    1. A0043AGE02
      Text in Illustration
      *a Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. Connect the connectors to the spiral cable sub-assembly.

  9. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  10. INSTALL STEERING PAD

    Click here