DATA LIST
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Meter Vehicle Velocity | Vehicle speed from meter/ Min.: 0.0 km/h (0.0 MPH) Max.: 300.0 km/h (186.4 MPH) |
0 km/h (0 MPH) | Power switch on (READY) and vehicle stopped |
| No significant fluctuation | Power switch on (READY) and vehicle driven at a constant speed | ||
| Motor Actual Current | Amount of current to motor/ Min.: -327.68 A Max.: 327.67 A |
Value changes in proportion to steering effort - The value rises in left turn - The value descends in right turn |
Power switch on (READY) and steering wheel being turned |
| Command Value Current | Demanded amount of current to motor/ Min.: -327.68 A Max.: 327.67 A |
Value changes in proportion to steering effort - The value rises in left turn - The value descends in right turn |
Power switch on (READY) and steering wheel being turned |
| Steering Angle Velocity | Steering angle speed/ Min.: -32768 deg/s Max.: 32767 deg/s |
Value changes in proportion to steering speed - The value rises in left turn - The value descends in right turn |
Power switch on (READY) and steering wheel being turned |
| Thermistor Temperature | ECU substrate temperature/ Min.: -50.0°C (-58.0°F) Max.: 150.0°C (302.0°F) |
-50°C to 150°C (-58°F to 302°F) | Power switch on (READY) |
| PIG Power Supply | Power source voltage to active motor/ Min.: 0.0000 V Max.: 20.1531 V |
9 to 16 V | Always |
| IG Power Supply | IG power source voltage/ Min.: 0.0000 V Max.: 20.1531 V |
9 to 16 V | Power switch on (IG) |
| Steering Angle Sens Sig | Steering angle sensor signal state/ OK or NG(1) or NG(2) or NG(3) |
OK: Steering angle sensor signal received NG(1): Learning has not completed NG(2): Steering sensor abnormal NG(3): Communication error |
- |
| Steering Wheel Torque | Steering wheel torque/ Min.: -327.68 Nm Max.: 7.00 Nm |
Value changes in proportion to steering effort - The value rises in left turn - The value descends in right turn |
Power switch on (READY) and steering wheel being turned |
| Motor Rotation Angle | Motor rotation angle/ Min.: 0.000 deg Max.: 1441.770 deg |
During steering operation, motor rotation angle value changes from 0 to 360° | Power switch on (READY) and steering wheel being turned |
| Command Val Current 2 | Demanded amount of current to motor/ Min.: -327.68 A Max.: 327.67 A |
Value changes in proportion to steering effort | Power switch on (READY) and steering wheel being turned |
| PIG2 Voltage | Coil rear pressurization voltage/ Min.: 0.000 V Max.: 45.955V |
9 to 16 V | Power switch on (READY) |
| Motor Voltage | Motor power supply voltage/ Min.: 0.000 V Max.: 45.955V |
Approximately 27 V | Power switch on (READY) and steering wheel not being turned |
| Value changes within 4 to 35 V range | Power switch on (READY) and steering wheel being turned | ||
| Motor Terminal Volt (U) | Motor terminal voltage (U phase)/ Min.: 0.000 V Max.: 98.000 V |
Value changes within 4 to 35 V range | Power switch on (READY) and steering wheel being turned |
| Motor Terminal Volt (V) | Motor terminal voltage (V phase)/ Min.: 0.000 V Max.: 98.000 V |
Value changes within 4 to 35 V range | Power switch on (READY) and steering wheel being turned |
| Motor Terminal Volt (W) | Motor terminal voltage (W phase)/ Min.: 0.000 V Max.: 98.000 V |
Value changes within 4 to 35 V range | Power switch on (READY) and steering wheel being turned |
| Torque Sensor 1 Output | Torque sensor voltage/ Min.: 0.0000 V Max.: 4.9725 V |
2.3 to 2.7 V | Power switch on (READY) and steering wheel not turned (without load) |
| 2.5 to 3.8 V | Power switch on (READY) and steering wheel being turned to the right with vehicle stopped | ||
| 1.2 to 2.5 V | Power switch on (READY) and steering wheel being turned to the left with vehicle stopped | ||
| Torque Sensor 2 Output | Torque sensor voltage/ Min.: 0.0000 V Max.: 4.9725 V |
2.3 to 2.7 V | Power switch on (READY) and steering wheel not turned (without load) |
| 1.2 to 2.5 V | Power switch on (READY) and steering wheel being turned to the right with vehicle stopped | ||
| 2.5 to 3.8 V | Power switch on (READY) and steering wheel being turned to the left with vehicle stopped | ||
| TRQ1 Zero Point Value | Torque sensor voltage/ Min.: 0.0000 V Max.: 4.9725 V |
Values differ depending on vehicle | Power switch on (READY) and steering wheel not being turned |
| TRQ2 Zero Point Value | Torque sensor voltage/ Min.: 0.0000 V Max.: 4.9725 V |
Values differ depending on vehicle | Power switch on (READY) and steering wheel not being turned |
| IG ON/OFF Times | Number of times of power switch ON/OFF after fail detection/ Min.: 0 times Max.: 65535 times |
- | This value indicates the number of times of power switch ON/OFF after the latest DTC detection. |
| Motor Overheat Record | Continuous overheat prevention control record/ Unrec or Rec |
Unrec | Unrec: Unrecorded Rec: Recorded |
| Motor Lo Power Record | PIG power source voltage drop record/ Unrec or Rec |
Unrec | Unrec: Unrecorded Rec: Recorded |
| Eng Rev Inter Record | Record of READY ON signal interruption/ Unrec or Rec |
Unrec | Unrec: Unrecorded Rec: Recorded |
| Str Angle Inter Record | Record of steering sensor signal interruption occurrence display/ Unrec or Rec |
Unrec | Unrec: Unrecorded Rec: Recorded |
| Spd Sig Invalid Record | Record of vehicle speed signal invalid/ Unrec or Rec |
Unrec | Unrec: Unrecorded Rec: Recorded |
| Battery Voltage Lo Record | Auxiliary battery voltage reduction history/ Min.: 0 times, Max.: 65535 times |
0 to 65535 times | - |
| Ready Status | Ready status/ OFF or Ready |
OFF or Ready | - |
| The Number of DTCs | Number of detected DTCs when freeze frame data stored/ Min.: 0 Max.: 255 |
0 to 255 | - |