PARKING BRAKE PEDAL (for RHD) REMOVAL


  1. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Tech Tips

    This is symmetrical to the LHD model Click here.

  2. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)

    Tech Tips

    This is symmetrical to the LHD model Click here.

  3. REMOVE FRONT SEAT ASSEMBLY RH (for Power Seat)

    Click here

  4. REMOVE FRONT SEAT ASSEMBLY LH

    Tech Tips

    Perform the same procedure as for the RH side.

  5. REMOVE YAW RATE AND ACCELERATION SENSOR


    1. A0044BO

      Remove the 2 bolts and yaw rate and acceleration sensor.

    2. Disconnect the connector from the yaw rate and acceleration sensor.

  6. REMOVE NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    1. A004464

      Remove the 4 bolts and No. 2 belt anchor reinforcement sub-assembly.

  7. REMOVE NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY


    1. A0041H3

      Remove the 4 bolts and No. 3 belt anchor reinforcement sub-assembly.

  8. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY


    1. A0041FU

      Disengage the 2 claws to remove the No. 1 air duct sub-assembly.

  9. LOOSEN ADJUSTING NUT


    1. A0043QPE01
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Remove the lock nut and loosen the adjusting nut.

  10. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. A0041F4E01
      Text in Illustration
      *1 Turn
      *2 Hold

      Separate the No. 1 parking brake pull rod sub-assembly from the parking brake control pedal assembly as shown in the illustration.

  11. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. A0040GL

      Remove the 5 bolts and separate the No. 1 parking brake cable assembly.

    2. Disengage the clamp.

    3. A0040LD

      Disconnect the parking brake switch connector.

    4. Disengage the wire harness clamp.

    5. A003ZYN

      Remove the 2 bolts, nut and parking brake control pedal assembly.