SKID CONTROL BUZZER (for RHD) REMOVAL

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Perform the same procedure as for the LH side Click here.

  4. REMOVE COWL SIDE TRIM BOARD RH

    Tech Tips

    Perform the same procedure as for the LH side Click here.

  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Tech Tips

    Perform the same procedure as for the LHD Click here.

  6. REMOVE ECU INTEGRATION BOX RH


    1. Disconnect the connectors from the ECU integration box RH.

    2. A0043G9

      Remove the bolt, nut and ECU integration box RH.

  7. REMOVE SKID CONTROL BUZZER ASSEMBLY


    1. A00423M

      Disengage the clamp to remove the skid control buzzer assembly.

    2. Disconnect the connector from the skid control buzzer assembly.