STEERING ANGLE SENSOR INSTALLATION

INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
1. Install the spiral cable with sensor sub-assembly Click here.
  Note
  - Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the power switch on (IG).
  - Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the power switch on (IG).
  - Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
  - Do not remove the steering angle sensor from the spiral cable.
INSTALL UPPER STEERING COLUMN COVER
1. Engage the 2 claws and 2 pins to install the upper steering column cover.
INSTALL LOWER STEERING COLUMN COVER
Note

If the lower steering column cover is installed in the incorrect order, it will not be possible to assemble the lower steering column cover.
1. Engage the 2 claws to install the lower steering column cover.
2. Engage the 4 claws.
3. Engage the 2 claws.
  
  Tech Tips
  
  Press the area around the claws to engage them.
ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
1. Check that the power switch is off.
2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
3. Rotate the spiral cable counterclockwise slowly by hand until it stops.
  
  Note
  
  Do not turn the spiral cable using the airbag wire harness.
4. Text in Illustration
  
  *a Alignment Mark
  
  Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
  
  Note
  
  Do not turn the spiral cable using the airbag wire harness.
  
  Tech Tips
  
  The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.
INSTALL STEERING WHEEL ASSEMBLY

Click here