FRONT SPEED SENSOR REMOVAL

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. REMOVE FRONT FENDER LINER

    Tech Tips

    Use the same procedure for the LH side and RH side Click here.

  4. REMOVE FRONT SPEED SENSOR


    1. A0040AC

      Remove the 2 clamps and disconnect the front speed sensor connector.

    2. A00427UE01
      Text in Illustration
      *1 No. 2 Sensor Clamp

      Remove the bolt and No. 2 sensor clamp from the body.

    3. A00426RE01
      Text in Illustration
      *1 No. 1 Sensor Clamp
      *2 Front Brake Flexible Hose

      Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the shock absorber assembly.

    4. Remove the clamp from the shock absorber.

    5. A0041AX

      Remove the bolt and front speed sensor.

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.