TCM REMOVAL


  1. REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  2. REMOVE DECK FLOOR BOX RH


    1. A00440B

      Disengage the claw and 4 guides and remove the deck floor box RH.

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A0042YL

      Disengage the 3 claws and guide.

    2. Disconnect each connector and remove the No. 2 instrument panel under cover sub-assembly.

  5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    1. for LHD:


      1. A004427E01
        Text in Illustration
        *1 Glove Compartment Door Stopper Sub-assembly
        *2 Moulding Remover
        *3 Lower Instrument Panel Sub-assembly
        *4 Glove Compartment Door Assembly
        *5 Stopper

        Disengage the claw and release the glove compartment door stopper sub-assembly.

      2. Insert the moulding remover into the location shown in the illustration.

      3. Move the moulding remover in the direction indicated by the arrow to bend the lower instrument panel sub-assembly and release the stopper (A).

        Tech Tips

        Use the same procedure to release the stopper (B).

    2. for RHD:


      1. A0043ACE01
        Text in Illustration
        *1 Glove Compartment Door Stopper Sub-assembly
        *2 Stopper

        Disengage the claw and release the glove compartment door stopper sub-assembly.

      2. Slightly bend stoppers (A) and (B) in the directions indicated by the arrows in the illustration and pull the glove compartment door assembly until the stoppers are released.

    3. A00430KE01
      Text in Illustration
      *a Close
      *b Open Approximately

      Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.

      Note

      Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.

  6. REMOVE ECU INTEGRATION BOX (for LHD)


    1. Disconnect each connector.

    2. A00409K

      Disengage the 3 clamps and disconnect the wire harness.

    3. Remove the bolt, 2 nuts and ECU integration box.

  7. REMOVE ECU INTEGRATION BOX (for RHD)


    1. Disconnect each connector.

    2. A0041AA

      Disengage the clamp and disconnect the wire harness.

    3. Remove the bolt, nut and ECU integration box.

  8. REMOVE TRANSMISSION CONTROL ECU ASSEMBLY


    1. A0040SSE02
      Text in Illustration
      *A LHD
      *B RHD
      *1 Transmission Control ECU Assembly
      *a Claw

      Disengage the 2 claws and remove the transmission control ECU assembly from the ECU integration box.