SHIFT CONTROL ACTUATOR REMOVAL


  1. REMOVE NO. 1 ENGINE UNDER COVER

  2. REMOVE SHIFT CONTROL ACTUATOR ASSEMBLY


    1. A00401N

      Disconnect the connector from the shift control actuator assembly.

    2. A00407K

      Remove the 3 shift control actuator bolts and shift control actuator assembly.

      Tech Tips


      • Please refer to Service Bulletin for details on the removal procedure of the shift control actuator bolt.

      • This actuator is a precision instrument. Do not strike it with a plastic hammer or the like during installation.

      • This actuator detects its own position when a battery is reinstalled. Thus it does not require initialization.

  3. REMOVE SHIFT CONTROL ACTUATOR SEAL

    Note

    It is not always necessary to replace or remove/install the shift control actuator seal at the same time when replacing the shift control actuator assembly.

    Tech Tips

    Remove/install the shift control actuator seal only if oil leaks from the shift control actuator seal or other faults are found when the shift control actuator assembly is removed.


    1. Using a screwdriver with the tip taped, remove the shift control actuator seal.

      Note

      When removing the shift control actuator seal, be sure not to damage the case or manual shaft with the screwdriver.