FRONT DOOR GLASS WEATHERSTRIP INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL FRONT DOOR OUTER GLASS WEATHERSTRIP ASSEMBLY LH


    1. Attach the 5 claws to install the front door outer glass weatherstrip.

  2. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH


    1. Temporarily install the power window regulator master switch assembly with front door armrest base panel.

    2. Connect the cable to the negative (-) battery terminal.

    3. Operate the front door window regulator so that the front door glass can be installed.

    4. Disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    5. Remove the power window regulator master switch assembly with front door armrest base panel.

    6. A01J51BE01

      Insert the front door glass into the front door panel along the front door glass run as indicated by the arrows in the order shown in the illustration.

    7. Install the front door glass with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL FRONT DOOR SERVICE HOLE COVER LH


    1. Apply new butyl tape to the front door panel.

    2. A01J482E01
      Text in Illustration
      *a Reference Point

      Pass the front door inside locking cable, front door lock remote control cable and wire harness through a new front door service hole cover, and then install the front door service hole cover using the reference points on the front door panel.

  4. INSTALL FRONT DOOR NO. 1 TRIM BRACKET


    1. Install the front door No. 1 trim bracket with the 2 screws.

  5. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH


    1. A01J3N7

      Connect the front door inside locking cable and front door lock remote control cable to the front door inside handle.

    2. Attach the 2 guides as indicated by the arrow in the illustration, and then attach the claw to install the front door inside handle.

  6. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

    A01J4FP

    1. Install the outer rear view mirror assembly LH with the 3 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 ft.*lbf }

    2. w/ Power Mirror Control System:

      Connect the connector.

  7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. Attach the 8 clips to install the front door trim board.

    2. Install the screw and clip.

  8. INSTALL DOOR PULL HANDLE


    1. Install the door pull handle with the screw.

  9. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    1. Attach the 2 clips to install the front door lower frame bracket garnish.

  10. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    1. Connect the connector.

    2. Attach the 4 claws and 2 clips to install the power window regulator switch assembly with front door armrest base panel.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.