OUTER REAR VIEW MIRROR REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH (for Driver Side)


    1. A01J46B

      Using a moulding remover, detach the 2 clips and 4 claws.

    2. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.

  2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (for Front Passenger Side)


    1. A01J40S

      Using a moulding remover, detach the 2 clips and 4 claws.

    2. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    1. A01J5X9

      Detach the 2 clips and remove the front door lower frame bracket garnish.

  4. REMOVE DOOR PULL HANDLE


    1. A01J3V5

      Remove the screw and door pull handle.

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01J6S3E01
      Text in Illustration
      *1 Clip
      *2 Screw

      Remove the clip and screw.

    2. Detach the 8 clips and remove the front door trim board.

  6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    A01J6DA

    1. w/ Power Mirror Control System:

      Disconnect the mirror connector.

    2. Remove the 3 nuts.

    3. Push down the claw and remove the outer rear view mirror assembly LH.

  7. REMOVE OUTER MIRROR LH


    1. Using a screwdriver, detach the 2 claws as shown in the illustration.

      A01J5LRE01
      Text in Illustration
      *1 Screwdriver *2 Protective Tape

      Note

      Do not pull the outer mirror LH with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

      Tech Tips

      Apply protective tape to the mirror body and screwdriver tip.

    2. A01J6SH

      Detach the 2 claws at the upper part of the outer mirror.

    3. Remove the outer mirror LH.

  8. REMOVE OUTER MIRROR COVER LH


    1. A01J5ARE01
      Text in Illustration
      *1 Tape

      Remove the tape.

    2. A01J7HL

      Remove the screw, detach the 5 claws and remove the rubber base.

      Tech Tips

      It is not necessary to completely remove the rubber base. Slightly move the rubber base so that the outer mirror cover LH can be removed in a later step.

    3. A01J600

      Using a T25 "TORX" socket wrench, remove the 3 screws.

    4. A01J5JI

      Using a T25 "TORX" socket wrench, remove the screw.

    5. A01J3G9

      Remove the 3 screws.

    6. Detach the 6 claws.

      A01J4BJE01

    7. Detach the 2 claws and remove the outer mirror cover LH as shown in the illustration.