POWER WINDOW CONTROL SYSTEM (w/o Jam Protection Function) Driver Side Power Window does not Operate with Power Window Master Switch

DESCRIPTION

If the manual UP / DOWN and AUTO DOWN functions do not operate, a malfunction may be present in the power window regulator master switch, power window regulator motor or wire harness.

WIRING DIAGRAM

A01J7M6E09

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER SIDE)

    A01J3XJE01

    1. Remove the motor Click here.

    2. Apply battery voltage to connector terminals 1 and 2.

      Note

      Do not apply battery voltage to any terminals except terminals 1 and 2.

    3. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 1

      Battery negative (-) → 2

      		 Motor gear rotates counterclockwise

      Battery positive (+) → 2

      Battery negative (-) → 1

      		 Motor gear rotates clockwise

    NG

    REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY

    OK

  2. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DRIVER SWITCH)


    1. A01J5X1E20

      Remove the master switch Click here.

    2. Measure the resistance of the switch when the switch is operated.

      Standard resistance
      Window Lock Switch Condition Power Window Switch Condition Tester Connection Specified Condition

      Always

      (ON / OFF)

      		 UP

      3 (E) - 9 (DD)

      4 (DU) - 6 (B)

      		 Below 1 Ω

      Always

      (ON / OFF)

      		 OFF

      3 (E) - 4 (DU)

      3 (E) - 9 (DD)

      		 Below 1 Ω

      Always

      (ON / OFF)

      		 DOWN

      3 (E) - 4 (DU)

      6 (B) - 9 (DD)

      		 Below 1 Ω

      Always

      (ON / OFF)

      		 AUTO DOWN

      3 (E) - 4 (DU)

      6 (B) - 9 (DD)

      		 Below 1 Ω

    NG

    REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

    OK

  3. CHECK WIRE HARNESS (MASTER SWITCH - MOTOR (FOR DRIVER SIDE))

    A01J4Z7E09

    1. Disconnect the P6 master switch connector.

    2. Disconnect the P7 motor connector.

    3. Measure the resistance of the wire harness side connectors.

      Standard resistance
      Tester Connection Specified Condition
      P6-9 (DD) - P7-1 Below 1 Ω
      P6-4 (DU) - P7-2 Below 1 Ω
      P6-9 (DD) or P7-1 - Body ground 10 kΩ or higher
      P6-4 (DU) or P7-2 - Body ground 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS AND CONNECTOR

    OK

    GO TO POWER WINDOWS DO NOT OPERATE AT ALL