OUTER REAR VIEW MIRROR INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL OUTER MIRROR COVER LH


    1. Attach the 2 claws as shown in the illustration.

      A01J77CE01

    2. Attach the 6 claws to install the outer mirror cover LH.

    3. A01J5N6

      After installing the outer mirror cover, check that there is no gap between the cover and mirror body.

      If there is a gap between the cover and body, noise will occur during driving.

    4. A01J4HSE01
      Text in Illustration
      *1 Adhesive

      Using a T25 "TORX" socket wrench, install the screw.

      Tech Tips


      • Clean the threads of the screw with non-residue solvent.

      • Apply adhesive to the threads of the screw.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    5. A01J4V9E01
      Text in Illustration
      *1 Adhesive

      Using a T25 "TORX" socket wrench, install the screws.

      Tech Tips


      • Clean the threads of the screws with non-residue solvent.

      • Apply adhesive to the threads of the screws.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    6. Attach the 5 claws.

    7. Install the rubber base with the screw.

    8. A01J2ZZE01
      Text in Illustration
      *1 Tape
      *a 40 mm (1.58 in.)

      Apply new tape as shown in the illustration.

  2. INSTALL OUTER MIRROR LH


    1. A01J5N1

      Attach the 2 claws as shown in the illustration.

    2. A01J7L0

      Attach the 2 clips to install the outer mirror LH.

      Note

      Do not push in the glass with excessive force. Doing so may break the mirror surface.

  3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

    A01J4FP

    1. Install the outer rear view mirror assembly LH with the 3 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 ft.*lbf }

    2. w/ Power Mirror Control System:

      Connect the connector.

  4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. Attach the 8 clips to install the front door trim board.

    2. Install the screw and clip.

  5. INSTALL DOOR PULL HANDLE


    1. Install the door pull handle with the screw.

  6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    1. Attach the 2 clips to install the front door lower frame bracket garnish.

  7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH (for Driver Side)


    1. Connect the connector.

    2. Attach the 4 claws and 2 clips to install the power window regulator switch assembly with front door armrest base panel.

  8. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (for Front Passenger Side)


    1. Connect the connector.

    2. Attach the 4 claws and 2 clips to install the power window regulator master switch assembly with front door armrest base panel.