STEREO JACK ADAPTER ASSEMBLY REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01J6ZME01
    Text in Illustration
    *1 Stopper

    1. Slightly bend the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.

    2. A01J44JE01
      Text in Illustration
      *1 Hinge

      Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.

  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    A01J74M

    1. Detach the 2 claws, 3 clips and 3 guides and remove the lower instrument panel finish panel.

  5. REMOVE SWITCH BASE

    A01J443

    1. Detach the 8 claws.

      Tech Tips

      If the claws are difficult to detach, detach the claws from the back of the switch base.

    2. Disconnect the connectors and remove the switch base.

  6. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY


    1. A01J684

      Detach the 2 claws and remove the stereo jack adapter.