AUDIO AND VISUAL SYSTEM (for Radio and Display Type) Display Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

A01J6ZCE08

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the R19 radio and display receiver assembly connector.

    2. Disconnect the N5 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      R19-13 (VV+) - N5-6 (VV+) Always Below 1 Ω
      R19-14 (VV-) - N5-11 (VV-)
      R19-13 (VV+) - Body ground Always 10 kΩ or higher
      R19-14 (VV-) - Body ground
      R19-12 (SG) - Body ground

    NG
    OK