REAR DOOR SPEAKER INSTALLATION

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR SPEAKER ASSEMBLY


    1. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.

    2. A01J71M

      Using an air riveter or hand riveter, install the speaker with 3 new rivets.

      Note


      • A01J68OE19

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

        Text in Illustration
        *1 Mandrel
        *2 Riveter
        *a INCORRECT
        *b CORRECT
      • A01J3QWE19

        Confirm that the rivets are seated properly against the speaker.

        Text in Illustration
        *1 Riveter
        *a INCORRECT
        *b CORRECT

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • A01J6COE17

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

        Text in Illustration
        *1 Riveter
        *a INCORRECT
        *b CORRECT

    3. Connect the connector.

  2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. Attach the 10 clips to install the rear door trim board.

    2. Install the screw.

  3. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. Connect the connector.

    2. Attach the 2 claws and 2 clips to install the rear power window regulator switch assembly with rear door armrest base panel.

  4. INSTALL DOOR PULL HANDLE


    1. Install the door pull handle with the screw.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.