METER / GAUGE SYSTEM Driver Side Seat Belt Warning Light does not Operate

WIRING DIAGRAM

A01J4AEE36
A01J4AEE37

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK SEAT TYPE


    1. Check seat type.

      Result
      Result Proceed to
      w/ Power Seat Control System A
      w/o Power Seat Control System B

    B

    INSPECT FRONT SEAT INNER BELT ASSEMBLY LH Click here

    A

  2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (BUCKLE SWITCH)

    A01J60UE02

    1. Disconnect the F24 front seat inner belt assembly LH connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 4 Seat belt is unfastened Below 1 Ω
      1 - 4 Seat belt is fastened 1 MΩ or higher

    NG

    REPLACE FRONT SEAT INNER BELT ASSEMBLY LH Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT LH - COMBINATION METER)


    1. Disconnect the F24 front seat inner belt assembly LH connector.

    2. Disconnect the C27 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F24-1 - C27-11 (BKL) Always Below 1 Ω
      F24-4 - Body ground Always Below 1 Ω
      F24-1 - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here

  4. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH

    A01J3EME02

    1. Disconnect the F11 front seat inner belt assembly LH connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Seat belt is unfastened Below 1 Ω
      1 - 2 Seat belt is fastened 1 MΩ or higher

    NG

    REPLACE FRONT SEAT INNER BELT ASSEMBLY LH Click here

    OK

  5. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT LH - COMBINATION METER)


    1. Disconnect the F11 front seat inner belt assembly LH connector.

    2. Disconnect the C27 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F11-1 - C27-11 (BKL) Always Below 1 Ω
      F11-2 - Body ground Always Below 1 Ω
      F11-1 - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here