METER / GAUGE SYSTEM DIAGNOSIS SYSTEM


  1. DESCRIPTION

    Meter / Gauge system data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.

  2. CHECK DLC3

    A01J50IE50
    A01J7DQE02

    The vehicle's ECM uses the ISO 14230 (M-OBD) communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-03 and matches the ISO 14230 format.

    Symbols (Terminal No.) Terminal Description Condition Specified Condition
    SIL (7) - SG (5) Bus "+" line During transmission Pulse generation
    CG (4) - Body ground Chassis ground Always Below 1 Ω
    SG (5) - Body ground Signal ground Always Below 1 Ω
    BAT (16) - Body ground Battery positive Always 11 to 14 V

    If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

    Tech Tips

    Connect the cable of the intelligent tester to the DLC3, turn the ignition switch ON and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.


    • If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.

    • If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.