REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR GROMMET


    1. A01J655E01
      Text in Illustration
      *1 MP grease

      Apply MP grease to the entire inner surface of the wiper motor grommet.

      Tech Tips

      Make sure that grease is applied so that the grooves in the grommet are filled with grease, but not so that the hole of the grommet becomes clogged with grease.

    2. A01J50XE01
      Text in Illustration
      *1 Position Mark

      Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.

  2. INSTALL REAR WIPER MOTOR ASSEMBLY

    A01J4A7

    1. Install the wiper motor with the 3 bolts.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

    2. Connect the connector.

  3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

    2. A01J3JSE01
      Text in Illustration
      *1 Wiper Arm Pivot Serrations
      *2 Wire Brush
      *3 Wiper Pivot Serrations

      Clean the wiper pivot serrations with a wire brush.

    3. A01J4O0E01
      Text in Illustration
      *1 Ceramic Line

      Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

      Tech Tips


      • Hold down the arm hinge by hand while tightening the nut.

      • Install the arm and blade so that the rear wiper blade is aligned with the ceramic line.

    4. Operate the rear wiper while spraying water or washer fluid on the glass. Make sure that there is no interference between the blade and pillar.

    5. A01J30X

      Close the wiper arm head cap.

  4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    1. Attach the 16 clips to install the back door trim board.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.