FRONT WIPER MOTOR INSPECTION


  1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY

    A01J3I3E67

    1. Check the LO operation.


      1. Connect the battery's positive (+) lead to terminal 1 (+1) and the negative (-) lead to terminal 5 (E), and check that the motor operates at low speed (LO).

        OK
        Motor operates at low speed (LO).

    2. Check the HI operation.


      1. Connect the battery's positive (+) lead to terminal 4 (+2) and the negative (-) lead to terminal 4 (E), and check that the motor operates at high speed (HI).

        OK
        Motor operates at high speed (HI).

    3. Check the automatic stop operation.


      1. Connect the battery's positive (+) lead to terminal 1 (+1) and the negative (-) lead to terminal 5 (E). With the motor rotating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

      2. Using SST, connect terminals 1 (+S) and 1 (+1). Then connect the battery's positive (+) lead to terminal 2 (B) to restart the motor operation at low speed (LO).

        SST
        09843-18040
      3. A01J7LJE01
        Text in Illustration
        *a Automatic Stop Position

        Check that the motor stops automatically at the automatic stop position.

        Standard Area Standard Condition
        A 14° to -1°
        OK
        Refer to illustration on left.

        If the result is not as specified, replace the motor assembly.