HAZARD WARNING SWITCH REMOVAL

Tech Tips


  • Use the same procedures for the RH and LH sides.

  • The procedures listed below are for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER

    A01J3ELE01

    1. for Manual Air Conditioning System:


      1. Put protective tape around the center instrument cluster finish panel.

      2. Using a moulding remover, detach the 10 claws and 4 clips.

      3. A01J3P7
        Text in Illustration
        *1 Protective Tape

        Detach the 4 claws and disconnect the air conditioner control.

      4. Disconnect the connectors and remove the center instrument cluster finish panel.

    2. A01J7H9E01
      Text in Illustration
      *1 Protective Tape

      for Automatic Air Conditioning System:


      1. Put protective tape around the center instrument cluster finish panel.

      2. Using a moulding remover, detach the 8 claws and 4 clips.

      3. Disconnect the connectors and remove the center instrument cluster finish panel.

  3. REMOVE HEATER CONTROL KNOB (for Manual Air Conditioning System)

    A01J3IE

    1. Remove the No. 2 heater control knob as shown in the illustration.

  4. REMOVE FRE/REC CONTROL KNOB (for Manual Air Conditioning System)

    A01J3YU

    1. Remove the heater control knob as shown in the illustration.

  5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for Manual Air Conditioning System)

    A01J6PNE01

    1. Detach the 2 claws and remove the switch.