IGNITION KEY CYLINDER LIGHT REMOVAL

Tech Tips


  • Use the same procedures for the RH and LH sides.

  • The procedures listed below are for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE STEERING PAD ASSEMBLY


    1. A01J6MBE01
      Text in Illustration
      *1 Screw Case

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A01J6EJ

      Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the connector and remove the steering pad.

      Note

      When handling the airbag connector, do not damage the airbag wire harness.

  4. REMOVE STEERING WHEEL ASSEMBLY


    1. Remove the steering wheel set nut.

    2. A01J3RME02

      Place matchmarks on the steering wheel and main shaft.

    3. Using SST, remove the steering wheel.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

  5. REMOVE STEERING COLUMN COVER LOWER


    1. A01J4NQE01

      Remove the 3 screws and lower cover.

  6. REMOVE STEERING COLUMN COVER UPPER

  7. REMOVE KEY CYLINDER LIGHT ASSEMBLY


    1. A01J52O

      Using a screwdriver, detach the claw key cylinder light assembly in the direction indicated by the arrow in the illustration and remove it.

    2. Disconnect the connector.